Installation Tips:
With the lens off, push the light housing into the cove in your hood. You can also pinch the top and bottom of the housing if you’re concerned about your paint.
Once the housing is pushed all the way into the cove, it will seat automatically.
Don’t worry if there is a little play; the lens will secure the housing once installed.
Next, place the lens over the housing and insert the top and bottom screws. Tighten them using a screwdriver (not a drill or similar tool). DO NOT OVER TIGHTEN!!! Keep in mind that the housings are made of plastics and could possibly strip. Once the screw feels snug, you are done.
Finally, insert and tighten the screw on each side. As you tighten, press the lens toward the hood to avoid putting stress on the screw’s threads. Again, be careful not to over tighten. These screws just need to be snug.
Congratulations! You have installed the new lights!
Wiring Tips:
You can wire these a number of different ways to achieve the look you want.
The black wire is the ground. The red wire is the running light. The yellow wire is the turn signal.
If you want the parking lights to turn on at startup and run continuously, you can connect the red wires to an accessory circuit in your system.
If you want the lights to turn on and off like the stock setup, just splice the wires into your stock harness.
If you want to keep the stock harness intact, you can use an adapter like this one from Amazon: https://www.amazon.com/dp/B0B42GRZXC?psc=1&ref=ppx_yo2ov_dt_b_product_details
In all installations, you must ground the black wire to your hood. The stock light housings are metal and ground (poorly) through contact with your hood.
Legal Disclaimers and Terms of Use:
Shindell & Sons Motorworks LLC products are intended for off road or competition use only.
Shindell & Sons Motorworks products are intended and sold for off road use only. Use of these products is at the customer’s own risk. Products sold for off road use are intended for off-road and racing vehicles that may never be used on public roadways. These off road only products may be illegal in many municipalities.
By purchasing aftermarket, off road only products, the customer takes full responsibility for any use and/or misuse of the product and agrees that Shindell & Sons Motorworks LLC holds no responsibility for any consequences, legal, or otherwise, of such use and/or misuse.