Installation Tips:
Remove your existing park lights.
Using the existing hardware, install the new lights into the stock location using the stock hardware.
Consult the wiring tips section for guidance before connecting the lights to your harness.
Congratulations! You have installed the new lights!
Wiring Tips:
You can wire these a number of different ways to achieve the look you want.
The black wire is the ground. The red wire is the running light. The yellow wire is the turn signal.
If you want the parking lights to turn on at startup and run continuously, you can connect the red wires to an accessory circuit in your system.
If you want the lights to turn on and off like the stock setup, just splice the wires into your stock harness.
If you want to keep the stock harness intact, you can use an adapter like this one from Amazon: https://www.amazon.com/dp/B0B42GRZXC?psc=1&ref=ppx_yo2ov_dt_b_product_details
In all installations, you must ground the black wire to your hood. The stock light housings are metal and ground (poorly) through contact with your hood.
Legal Disclaimers and Terms of Use:
Shindell & Sons Motorworks LLC products are intended for off road or competition use only.
Shindell & Sons Motorworks products are intended and sold for off road use only. Use of these products is at the customer’s own risk. Products sold for off road use are intended for off-road and racing vehicles that may never be used on public roadways. These off road only products may be illegal in many municipalities.
By purchasing aftermarket, off road only products, the customer takes full responsibility for any use and/or misuse of the product and agrees that Shindell & Sons Motorworks LLC holds no responsibility for any consequences, legal, or otherwise, of such use and/or misuse.